[JR_Gar_Fisher]

This can be accomplished without removing the console/bait well. It just takes a few more “cold ones”. I ran my TM battery charge wires and an extension cable for a bow mount locator. It is however not so much fun. I began by cutting the end off my fish tape and covered the sharp end with electrical tape. Also a little bend about ½” from the end will help get it by the bait well. Once it is pushed through from the bow and hits the bait tank you just have to push hard. The fish tape will curl around in the area under the bait well access cover. You will have to use a bent coat hanger or wire to hook it and pull it out the opening. Start by running a string only and do all the pulling from the bait well opening. The transducer cable has a big connector so I ran it first and pulled back another string for the charge wires. I spliced the charge wires in the console. Stealth on the run chargers “ROCK”!!!!! I never have to plug in.
At this point I would usually say “Luck and beers” but you have been there already!
JR