Crimar30,

As far as screwing anything into the hull run a search, there is plenty of detailed information. I haven't done it yet but make sure you use rule to seal the hole. As far as the warranty, Triumph replaced my boat due to a deformation in the hull. Other owners had had other problems are were satisfied with the service they recieved from either their dealer or the factory. I'm not implying that everyone that's ever had an issue left happy but from what I've read on this site the vast majority have been satisfied.

I have a Yamaha 4 stroke 60 on my 170DC on it will run 38 WOT with two people in it. That's more than I need or use. Base your motor size (60 or 75) on what you are planning to do with the boat. If you're looking to ski or tube consider going with the 75 if you're going to use it primarily for fishing the 60 should be norethan adequate.

As far as odd problems with roplene you won't get the pleasure of having to wax it. I hope that's not too much of a dissapointment. Seriously though, just make sure it is properly supported on the trailer or a bunk if stored out of the water and you should not have any problems.

Again, take the time to read the threads there's a lot of useful information in them. Like you I had some of the sam e questions when I was considering a Triumph. This site and the folks on it helped me make the decision to purchase the Triumph. I do not regret it.

Good luck in your decision.

Tom