Quote:
Originally Posted by Jim Jenkins
Tylerderdan,
Clean look on your installation. Questions: You stated the out riggers mounted right in the pre-made holes. Pre-made? Were there already plates welded in place on the T-top? Did you need to modify your canvas in any way? Taco looks like a good product. But are the pre-made holes universal to fit most outriggers on the market?
And a big question for other owners or a dealer out there. Is the T-top on the 195 CC also set up as you describe your 215 CC?
Thank you for this post. The value of this site is unlimited.
|
You know Jim I am not sure of the 195 cc compared to the 215. On the 215cc, and mine is a 2007 I had a hole pre-made for the taco outrigger setup. It even had the four drilled and tapped holes on each side in the precise location. The only thing I needed to do was use a razor blade and cut an X at the big hole and also at the four little holes for the mounting screws. Installation was easy.
I will get some more photos up as soon as I get the boat back. I will say this though, it certainly made things nice trolling this past weekend for albacore. I had a four lure spread and never one issue. In fact we had a couple triple hookups. I cannot wait for marlin season, and start dragging a nice spread with these. The outriggers put the outter lines about 12 feet from the boat, it was like being on big sportfisher.