|
Where is the hole located? I think I would get a piece of StarBoard, maybe 1/4 - 3/8 thick, and cut it about an inch bigger in each dimmension, round the corners, radius the edges, and use a few countersunk flat head Stainless Steel screws to hold it in place. It would look like a factory pannel.
You might even consider buying an aftermarket marine access port with a snap in or hinged cover that is larger than your existing hole. These covers don't look out of place on any boat.
Roger
__________________
"There is nothing, absolutely nothing, half so much worth doing as simply messing about in boats."
-Kenneth Grahame, The Wind in the Willows-
|