[HighTechRedneck]

On the rear deck of my boat there are 2 holes for extra seats. The table is sitting in these holes and is removeable. The holes are a little bigger than the 2 inch conduit I used so I wrapped duck tape to make up the difference and make a snug fit. I am going to find some heat srink tubing to take place of the duck tape but for now the duck tape will work. I have not tried it out on the water yet but it doesn't seem to move at all when i push and pull on it.

The only problem I have is the bimini top does not fold down. It is about 2 inches short to clear the table.

My next project is a foward leaning wakeboard tower with rocket launchers.