[jergofish]

Putershark, After your tale, I'm pretty much convinced that I need to drill the two drain holes, one starboard, one port and get the small transom plugs used on aluminum boats for each hole. I'll plug them and occasionally pull them as a check on water build up.

One, thing, no one responded to my question if all of the foam stringers in the boat are connected at the stern in that one foot or so of area? Looking at some of the literature, it appears that there are four main foam areas, two port and two starboard and two small stringers near the keel, again filled with foam. If they are all connected at the stern, the single drain or drains, inside or outside the transom, should be sufficient to drain them since most boats sit slightly down at the stern when in the water.