scuppers

[jferras]

Iam looking for better and improved scuppers. Viewed a post and a photo on buckbill scuppers. The photo was from Il-logoc-al. They may be just the thing I am looking for. If you have installed them, how well do they work? And where did you purchase them? Al can you help?

[Putershark]

Which hull model are you asking about?

[jferras]

The scuppers Iam looking for are called "duckbill" scuppers and would go no a 2001, 210 cc. I went to West Marine, and they didn't know what I was talkling about.

[Putershark]

Then they do not know how to look through their own online catalog By just dropping off the letter "s" at the end of the word, this was the first page I pulled up which has what you are looking for I think

http://www.westmarine.com/webapp/wcs...key=SiteSearch


Let me know if does not show the product you are looking to buy and I will keep searching

Enjoy!

[Putershark]

My mistake, I thoght the one about half way down had one built in... I have though changed my search topic on the Internet to "Duckbill Valve" and I am getting some more hits and ideas Here is the first few I have found so far that may help...

http://www.minivalve.com/htm/DV027.htm

http://www.minivalve.com/

https://www.vernay.com/products/duckbill.htm

http://www.daprorubber.com/subpage.asp?cat=3&id=5

Those links should keep you busy digging around for a while

[ILLOGICAL GGC]

hey j

the ball style scuppers i had on my 01 210cc were so badly worn where the ball was suppose to seal at the transom that water was running in and filling the rear fish boxes and deck.

one of our mackfest boaters who was down from new york state had a different style ball scup that had his transom and deck dry. i have since misplaced the brand and model number of those scups and opted for the duckbill style just to see if they would work and to stay on long enough to get those smaller ball scups on.
the ducks had done a surprisingly good ,but i'm afraid they may trap a piece of whatever and get stuck open which would be no better than the old ball style
so far so good
berto

[MolarBoater]

So far, ball scuppers have worked best for me. Whale makes a one way valve scupper that has a duck bill scupper inside but, the size of the duck bill is too small to let water out rapidly without unscrewing it.`