Mounting a depthfinder

[chakaman]

How is the best way to mount a transducer to the hull of th 150cc? Any suggestions on installation? Rigging is kinda new to me

ccm

[cagrove]

Most people mount the transducer on the transom with screws and Rule sealant. Remember to not overtighten the screws (just get them snug and stop, or they will strip out). Then run the wire back up the transom and through the rubber boot where your steering cables go. There is a black tube that runs from the center console to the rear of the boat with a string in it. Use that to run your cable to the console and then to your fishfinder. Good luck, I hope this helped.

[clk219th]

Originally Posted by cagrove

Most people mount the transducer on the transom with screws and Rule sealant. Remember to not overtighten the screws (just get them snug and stop, or they will strip out). Then run the wire back up the transom and through the rubber boot where your steering cables go. There is a black tube that runs from the center console to the rear of the boat with a string in it. Use that to run your cable to the console and then to your fishfinder. Good luck, I hope this helped.

I agree with Cagrove completely. I have a 150 Cool, and mounted mine myself, pretty much like Cagrove described. There's a good flat surface on the transom that should look like one of the sketches in the installation instructions. Mine has worked well since the install. The only thing I might add is to pre-drill the mounting holes so you get a good seat with the screws. Good luck, and I hope you find the fish.