Livewell Hose Leak

[Northman]

I've discovered a leak in the hose that goes to the livewell from the pump Actually not sure if the hose is coming in or going out, anyway, pretty sure the leak is due to a loosened hose clamp. Due to the location of the clamp up and under, I cannot get at it good enough to tighten it Any tricks or tips out there?

If not, how do I remove the pump to tighten the clamp and re-install

Thanks in advance.

[sritz05]

I went to Home Depot and picked up some clear poly reinforced tubing and just pushed it on as I pull the hose off to clean out the seacock valve when the debris gets bad and it has not leaked yet after two years. I do not worry though as I have two 1000 GPH bilges runining tandom with floats that activate if either side is full. The access issue I solved with two 6" access plates I put in my splash well makes life real easy when I need to get in the back.

[glyoung]

I had the same problem. Used a 5/16 socket instead of a screw driver and could tighten it without seeing it.

[Northman]

Thanks, guys. I'll give it a go again once it stops raining.