Transom Drain!!!!

[IT'LL DO]

YEP I JUST ATTEMPTED TO INSTALL THE TRANSOM DRAIN PLUG... CALLED THE FACTORY , THEY TOLD ME THE SAME AS I READ IN ON ONE OF THE FORUMS. DRILL ONE INCH TO THE RIGHT OF THE CENTER AND TWO INCHES OFF THE BOTTOM. WELL I DID JUST THAT AS I HAVE PICTURES WHICH WILL BE POSTED LATER AND I STILL RAN INTO THE STAINLESS BAR!!!!!!!!!!!!!!!! JUST BARELY. HOPEFULLY THE DRAIN PLUG I ORDERED ISNT VERY DEEP OR IM IN A WORLD OF ****... ESPECIALLY WHEN I ONLY GOT ABOUT A HALF OF GALLON OF WATER OUT. I GUESS THATS NOT NOT MY PLANING PROBLEM AFTER ALL, WELL, OFF TO THE NEXT PROBABILITY...TAYLOR.

[MolarBoater]

It matters exactly which model boat you are talking about. Might want to find out what happened with your directions from Triumph. That is an incorrect placement for a Bay 190.

[IT'LL DO]

I Have A 2004 21cc

[Codfish]

Taylor, Mine is an '04 210CC also. I too used the recommened measurements, which were 1 1/2 X 1 1/2 and just hit the stainless plate. I then posted that a 1/2" further to the right would be better. Sorry you missed that post. It is dated 2-23-05 and is named Inner/Outer Hull Drain. The good part is my plug still works just fine. I used the black plastic one with the red sealing ring on the screw out plug. The retention tabs on the plug hang up some but do not hamper the function of the plug. You may have to remove the retainer tabs but you will still have full thread contact to hold your plug in.

Glad to hear you only had a small amount of water come out. That is a good thing.
Codfish

[ILLOGICAL GGC]

now i know why randy and dick were hesitant when i insisted on having a logic forum for mods. and upgrades. if you guys had read the thread posted there on inner foam drains for the 210cc , you would have seen to go 2-1/2 right and 1-1/2 up. that measurement was taken from my boat that my dealer did the install on and it is a clear drill into the foam area. don't know if the "Logic" aspect of that forum kept you guys from reading it or not.
the logics have a unique set of design and mfg. issues ,but they are the aprox. same hulls and mods there are relative as to how the newer year models can be modified. 1-1/2 right has always been to close to the s.s. strap and i'm really sorry you got on it . that being said, the is still no reason the sea dog or even brass type drain fitting would not work.
as stated by randy and myself on the logic forum , your dealer is the best person to do any of the mods. as for me , i have a Q2 non warranty hull so whatever i do doesnt come under factory scruntney as you guys with warranties.
GGC