Improved Scupper 215cc

[walkerm]

Gents-

Kinda ran out of patience with the factory plastic scuppers that seem to act like a pump that runs backward.

I tried duck bills, one way valves made for commercial fish tanks along with the cheap stock scuppers.

I found these aluminum scuppers made for jet ski's. You have to slightly cut the bottom of the scupper to make it match up to the level of the 215 cc.
So far it is working well. They are expensive about $90.00 each. But I save that on frustration.

http://www.247innovations.com/pwc/products.htm


Monty Walker

[MolarBoater]

That looks like a metal version of the side scuppers on my 2002 Bay 190. Unfortunately, they kept little water out....but apparantly, 24-7 version is more effective with the metal.

I currently run the ball in cage type with good results but my dealer will be doing a factory warranty re-routing them out the transom.....not sure what will be installed over those.

[red herring]

Hey guys,
My '06 215cc came with the ping bong balls. At this point I am not disappointed in their performance . . . what does have my goat is the fact that the two inches of water remain in the stern wells because of the position of the thru holes being much higher than the bottom of the wells. Has anyone made any mods to let this puddle water drain out? Heck, I've had algae growing there!